CatchingĬatching happens when a layer catches on another layer on your speedcube. If you are a serous cuber then it is best to get a speedcube which will do well when tested for these characteristics as well. You should read them and understand them. These are not deal breaker characteristics but they will influence your 4×4 cube experience. This is not something you want to happen so you will want a stable cube. When it comes to 4×4 rubik’s cubes this can be a problem due to their complex design so when you are speedsolving it can pop up.Ĭan you imagine speedsolving your 4×4 in front of your friends or casually on the bus stop and having your speedcube violently explode scattering its pieces everywhere? Your 4×4 cube must have proper corner cutting which will not throw you out of balance and interrupt your algorithm execution. No one is that precise and nor should you be. This is going to happen very often and especially when you are speedsolving because you will overshoot when performing algorithms. This is one of the most important factors when it comes to 4×4 rubik’s cube because you don’t want your cube to be rigid and difficult to solve.Ĭorner cutting is the speedcubes ability to make a turn in a case where the vertical face is not fully aligned. Corner Cutting An example of bad corner cutting Having said that, you should avoid 4x4s which require too much effort to rotate the layers because the whole solving process is longer and you don’t want to get your hands tired. This results in less speed but with more control. Meaning that there is more friction between the layers. However, if you want more control, then you should go for a 4×4 cube which is smooth. This can result in overshooting which is slightly more dangerous with 4×4 speedcubes compared to 3x3s because you have more layers to accidentally mess up. If you like extreme speeds than you should go with the one that is very fast which will, in turn, sacrifice some control because of lack of smoothness. You will want to have a speedcube which resonates with your turning style. Speedcube can provide you with speed or smoothness or a mixture of both which is usually the case. Speed And SmoothnessĪny speed cube can be judged based on these characteristics. Even if you know about 3×3 rubik’s cube characteristics, you should still read about 4×4 because they are not all the same. The essential characteristics of 4x4s are quite important to understand. If you read anything other than the reviews below please read this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |